Bike Rack Types Comparison Table


Hitch Mount Bike Racks – This style of rack requires a trailer hitch receiver, and the cost of installation will range between $120 and $195 if your vehicle does not already have one installed. There are two distinct sizes of hitch receivers available (1.25 inches and 2 inches) to accommodate trailers with varying capacity. It is not difficult to move anywhere from one to five bicycles. Be sure to give versions that tilt or swing away from the tailgate serious consideration if you want to be able to reach the back of your car even when it is crammed full of bicycles. The rear of the vehicle is the most convenient spot to load bicycles into the transport vehicle.

Roof-Mounted Bike Racks – If your automobile does not already have a roof rack, you will need to purchase either a base roof rack or cross bars in order to attach the bike rack. The cost of these accessories may range anywhere from $200 to $450. Each bike is put into its own dedicated rack that is fitted atop the vehicle. There are two distinct styles of roof mount racks, each of which loads the bicycle onto the roof in a different manner: the first style mounts the front fork of the bicycle while removing the front wheel, and the second style mounts the bicycle in an upright position while leaving the front wheel in place. Getting a bicycle up onto the top of a car may be a challenging and hard endeavor.

Trunk Mount Bike Racks – This may be an alternative with a reduced cost overall, especially with cheaper entry racks; but, inexpensive entry versions can be fraught with risk. The best method to approach this kind of rack, in our view, is to search for ones that are of high quality and have been given reliable safety ratings. It should not be difficult to install or remove a roof rack from a trunk. It will be much simpler for you to load and unload your bicycles if you position them at the rear of the transport van.

Spare Tire Bike Racks – Racks that attach to the spare tire follow the same design principles as racks that attach to the trunk. All of the same advantages, as well as pitfalls to watch out for. This kind of rack has the capacity to accommodate anywhere from one to four bicycles. There are two different techniques to attach a rack for a spare tire. Straps around the spare tire, the efficiency of which is depending on the specific system, or alternatively, a receiver that is located behind the spare wheel that is fastened to. Assuming that the fitting is suitable for use with your spare tire, this gives a solution that is more trustworthy.

Truck Bed Bike Racks – prevent your stuff from shifting about in the back of the truck and may be installed in a variety of different ways, the degree of difficulty of which is highly dependent on the specific model that you choose. Some of them need to have holes drilled in them, while others have more modern anchoring methods that are simple to set up and take down. There are two different ways to load bicycles into these racks: one uses the front fork attachment, which requires the removal of the front wheel, and the other uses the upright loading method, which allows the front wheel to remain connected to the bicycle.

A short reference chart to assist you in selecting the kind of bike rack that would work the best for your specific requirements. Take a look at the comparison table that follows; it outlines 8 important factors that should be considered for each kind of bike rack.

Recent Posts